Relay Circuit Answers - Job #1
Here are the answers for the ten questions about this relay circuit. Check
your answers against these. On questions where you have a different response, go
back and reread the question. See where the answer given below is perhaps better
than the one you selected. Consult the assignment text, diagram, picture, and
lecture. Ask other electricians you may know to help you. Send me an email
if you feel I have made a mistake.
Redo all the test questions if you missed even only one. Each of the questions
is important to strengthen your understanding of this relay circuit diagram.
This is a learning exercise. Expect to miss a few as you learn.
Answers
1. press on the pushbutton to go closed
2. nothing. Or close master switch then press on pushbutton
3. coil will energize
4. nothing until "ON" pushbutton is pressed
5. bad coil
6. 120 volts
7. nothing will cause it to go to run
8. yes
9. nothing until master switch is closed then "ON" pushbutton is
pressed
10. apply power, master switch on, press "ON" pushbutton
Click HERE to go back to the question page for
this diagram.
When satisfied that you have a complete understanding of this diagram, click HERE
to go on to the next job.
|
